Buehler鑲嵌機SimpliMet 3000型產品特點：
可編程性降低復雜性
· 適用于有多種鑲嵌樣需求且鑲嵌尺寸不同的實驗室。
· 存儲和撤銷5種不同的程序，降低復雜性和消除錯誤， 提供靈活性來滿足多變的實驗室要求
通過選擇不同尺寸的模具來優化各種各樣的試樣大小。節約鑲嵌介質并提升鑲嵌質量
| Specifications |
|
| Operation | Automatic electro-hydraulic |
| Power Source | 85-264VAC, 50/60Hz, 1 phase |
| Molding Pressure | 1200 - 4400psi [80 - 300bar] in 100psi [5bar] increments |
| Molding Temperature | 120 - 360°F [50 - 80°C] in 20°F [10°C] increments |
| Heating Power | 1500Watt @ 115/230VAC |
| Heating Time | 0 - 20 minutes in 10 second increments |
| Cooling Time | 0 - 30 minutes in 10 second increments |
| Mold Type | Cylindrical, including upper and lower rams and duplex mold spacer |
| Closure Type | Insluated bayonet with piston indent |
| Mold Diameters | 1in, 1.25in, 1.5in, 2in, 25mm, 30mm, 40mm, 50mm |
| Touch-pad Controls | On/Off; Heat Time; Cool Time; Molding Temperature; Molding Pressure; Mold Size; Ram Up/Down; Maunal Cool; Cycle Start; Cylinder Open; Unit of Measure; Language and also including Thermoplastic; Load and Save Methods |
| Units of Measure | Imperial or Metric |
| Water Flow Rate | 0.5gal/min [2?/min] minimum |
| Water Pressure | 45-75psi [3-5bar] |
| Control Voltage | 24VDC |
| Method Programmability | 4 Buehler, Preprogrammed Methods per mold size; 25 User Definable Methods |
| Preload Pressure | 0 - 400psi [0 - 30bar] in 50psi [5bar] increments |
| Thermoplastic Function | Automatically sets correct parameters for thermoplastic resins such as TransOptic™ and cools the mount in a controlled, linear fashion |
| Compliance | In accordance with EC Directives |
所有評論僅代表網友意見，與本站立場無關。